Solar Charge Controller

10A 20A 30A solar charge controller 12v/24v auto detect

1.charging mode: PWM
2.light control+time control
3.protection grade:IP68
5.charging voltage:12v/24v
Product description: 10A 20A 30A solar charge controller 12v/24v auto detect
INQUIRY

Tech Data

Model	5A	10A	15A	20A	30A
Rated Charge Current	5A	10A	15A	20A	30A
Rated Load Current	5A	10A	15A	20A	30A
System Voltage	24V/12V AUTO
Over load, short circuit protection	1.25 times by rated current, 60 seconds, 1.5 times by rated current,5 seconds--- overload protection; ≥3 times by rated current--- short circuit protection
No- load Loss	≤6mA
Charge Circuit Voltage Drop	≤0.26V
Discharge Circuit Voltage Drop	≤0.15V
Over Voltage Protection	17V, ×2/24V
Working Temperature	Industrial Grade: -35℃-+55℃ (Suffix I )
Increase Charge Voltage	14.6V, ×2/24V (10 min when discharging)
Direct Charge Voltage	14.4V, ×2/24V (10 min )
Float Charge Voltage	13.6V, ×2/24V (till come down to charging recovery voltage)
Charge Recovery Voltage	13.2V, ×2/24V
Temperature Compensation	-5mv/℃/2v
Under Voltage	12.0V, ×2/24V
Over discharge Voltage	11.1V, ×2/24V
Over Discharge Recovery Voltage	12.6V, ×2/24V
Control Mode	PWM
Net Weight	160~200g

Part Three, Installation and application

1, To fasten the controller well,The outside size 140*90mm The hole size 133.5*70mm

2, The cable: to advise to use multi-strand insulated copper wire, to assure the cable can meet the installation needs, than keep it as short as possible, so that to reduce extra power consumption. The cable should no bigger than 4A/MM2, to strip 5MM for the controller side.

3, To connect the cable to the controller battery point first, than to connect the cable to the battery, pay attention to +/- pole, don’t put wrong connection. If it is correct, the LED-2 will be bright, to press the button to check it. Otherwise, to check the cable connection. In case of reverse, insurance and controllers will not burn any component damage. Fuse inside the controller itself only as a final short circuit protection circuit is damaged.

4, To connect the cable to the controller PV point, than to connect the cable to the PV, Pay attention to +/- pole, don’t put wrong connection. If there is sunshine, The LED-1 will be bright, otherwise, to check the cable connection.

5, To connect the load cable to the controller load point, Pay attention to +/- pole, don’t put wrong connection. Otherwise, it may burn the load.

PREVIOUS：2A 24 hours output solar charge controller NEXT：Outdoor Solar Camping Light, Portable Solar Camping/Travel Light with/without radio